M20 AI Vision Module Manual
M20 AI Vision English
M20 AI Vision English
  • Introduction
  • User Manual
    • Release Notes
    • M20 AI Vision Module
      • Revision History
      • 1 About this product
        • 1.1 Mounting and Installation
        • 1.2 Disposal method
        • 1.3 Security Information: How to Use the Website Safely
      • 2 How to Use
        • 2.1 How to connect to the host device
      • 3 How to operate the demo application
        • 3.1 Demo application for WindowsSDK
          • 3.1.1 When performing face recognition using images registered from the camera
          • 3.1.2 When performing face recognition with images registered from local storage
          • 3.1.3 When biometric detection is used
        • 3.2 Demo Application for LinuxSDK
          • 3.2.1 When performing face recognition using images registered from the camera
          • 3.2.2 When performing face recognition with images registered from local storage
          • 3.2.3 When biometric detection is used
        • 3.3 Demo Application for AndroidSDK
          • 3.3.1 When performing face recognition using images registered from the camera
          • 3.3.2 When biometric detection is used
        • 3.4 Demo Application for ARM LinuxSDK
          • 3.4.1 When performing face recognition using images registered from the camera
          • 3.4.2 When performing face recognition with images registered from local storage
          • 3.4.3 When biometric detection is used
          • 3.4.4 How to update the firmware
      • 4 Product Specifications
        • 4.1 Name of each department
        • 4.2 Device Specifications
      • 5 Target OS for SDK operation
      • 6 SDK Specifications
        • 6.1 Windows/Linux SDK
        • 6.2 Android SDK
        • 6.3 ARM Linux SDK
Powered by GitBook
On this page
  1. User Manual
  2. M20 AI Vision Module
  3. 3 How to operate the demo application
  4. 3.3 Demo Application for AndroidSDK

3.3.2 When biometric detection is used

Previous3.3.1 When performing face recognition using images registered from the cameraNext3.4 Demo Application for ARM LinuxSDK

Last updated 3 years ago

1 Select 1:N.

2 Confirm that the following screen is displayed, and then click Confirm that the following screen is displayed, and select "1:N Single face and open checking liveness" or "1:N Multi face and open checking liveness".

3 When the camera detects a face, make sure that anything other than NONLIVENESS is displayed above the detection frame.

If NONLIVENESS is displayed as shown below, biometric detection is not possible.